Mini Monitor Module FMM-101 Notifier

Spesifikasi Mini Monitor Module FMM-101 Notifier

FMM-101(A) SPECIFICATIONS
Nominal operating voltage: 15 to 32 VDC.
Average operating current: 350 μA, 1 communication every
5 seconds, 47k EOL; 600 μA Max. (Communicating, IDC
Shorted).
Maximum IDC wiring resistance: 40 ohms.
Maximum IDC Voltage: 11 Volts.
Maximum IDC Current: 400 μA.
EOL resistance: 47K ohms.
Temperature range: 32°F to 120°F (0°C to 49°C).
Humidity range: 10% to 93% noncondensing.

Dimensions: 1.3" (3.302 cm) high x 2.75" (6.985 cm) wide x
0.65" (1.651 cm) deep.
Wire length: 6" (15.24 cm) minimum.

 

Mini Monitor Module FMM-101 Notifier Application

FMM-101(A) APPLICATIONS
Use to monitor a single device or a zone of four-wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally-open dry-contact devices. May also be used to monitor normally-open supervisory devices with special super- visory indication at the control panel. Monitored circuit/device is wired as an NFPA Style B (Class B) Initiating Device Circuit. A 47K ohm End-of-Line Resistor (provided) terminates the cir- cuit.

FMM-101(A) OPERATION
Each FMM-101(A) uses one of the available module addresses on an SLC loop. It responds to regular polls from the control panel and reports its type and the status (open/nor- mal/short) of its Initiating Device Circuit (IDC).

Fungsi Mini Monitor Module FMM-101 Notifier

tipe identifikasi otomatis mendeteksi perangkat ini sebagai monitor module dalam panel, kebutuhan power secara langsung di handle oleh 2 wire SLC loop, sehingga tidak membutuhkan power tambahan. FMM-101(A) Mini Monitor Module dapat di pasang pada junction box berdekatan dengan perangkat yang dimonitor. Fungsi dari module ini adalah untuk monitor satu device atau zona 4 wire smoke detector, manual fire alarm pull station konvensional, perangkat laju aliran (waterflow devices), atau perangkat lain yang bekerja berdasarkan normally-open dry contact.

Produk Patigeni

Seluruh Produk